winged ring- brass wings on sterling silver

wings on sterling

draw some narrow wings on a piece of paper

stick/glue the wings to your metal sheet

I am using 20 gauge brass ( 0.8mm thick ) I usually do a mock up in metal that is cheaper before doing a sterling/gold version

draw your ring shank onto sterling silver

this is 18 gauge ( 1 mm thick )

cut out your wings and your ringshank via jewelry saw and 1/0 saw blades

make sure the ring shank and the wings fit ( I am good with eyeballing things – I tend not to measure )

solder your wings onto the ring shank

I use extra easy silver solder , after soldering quench in water and clean in Pickel solution

add your texture for the wings

cut the ring shank to length

bend until the ends meet flush and solder again

clean in the Pickel solution until the sterling turns from black to white

form the ring on a ring mandrel with a nylon hammer

polish inside

polish outside

add patina to bring out the texture

polish again

leave a bit of patina around the edges of the wings to bring out the design

I think this is more suitable for a male

what do you think ?

#art, #handmade-jewelry, #how-to, #how-to-make-a-bracelet, #how-to-make-jewelry, #jewelry-making, #jewelry-tutorials, #metal, #metal-art, #metal-shop, #metal-smithing, #metal-tutorials, #metal-work, #metalworking, #nicilaskin, #silver-smith, #silver-smithing, #smithing, #tutorial, #tutorials